Pressure Washing in Peoria, IL

More pressure is not better

The biggest mistake in this trade is treating every surface like a driveway. Concrete can take serious pressure. Vinyl siding, wood, and older brick cannot. Too much pressure on siding forces water up behind the panels where it sits against the sheathing. On wood it chews up the soft grain and leaves a furred surface that drinks stain unevenly. On old mortar it blasts the joints out.

We adjust the method to the surface. Most siding gets soft washed, meaning low pressure with a cleaning solution that does the actual work of killing mildew and algae at the root, so it stays clean longer instead of just looking blasted for a month. Concrete and pavers get the higher pressure they're built for. Wood decks and fences get a controlled wash that cleans without raising the grain.

What we clean

House siding is the most common call, especially the north side and shaded walls where green algae and mildew take hold. Driveways, sidewalks, and patios come up several shades brighter and lose the slick black film that gets treacherous when wet. We also wash fences, decks as prep before staining, garage floors, and the front walks and entries of small commercial buildings.

If you're having us paint your exterior, the wash is already built into that job. Painting over chalky, dirty siding is a guaranteed early failure, so we wouldn't skip it even if you asked. As a standalone service, most houses take a few hours and the difference is immediate.

What to expect

Before we start, close windows, move cars out of the splash zone, and let us know about any exterior outlets or fixtures that concern you. We work around landscaping and wet down plants near the house before and after applying any cleaning solution. When we're done, surfaces need time to dry fully before any painting or staining happens, usually a day or two depending on weather, and we check moisture rather than assuming.

Common questions about pressure washing

Will pressure washing damage my siding?

Not the way we do it. Vinyl, aluminum, and painted siding get soft washed with low pressure and a cleaning solution. High pressure is reserved for concrete and masonry that can handle it. Damage happens when someone points a 3,000-psi wand at vinyl. That's not us.

How often should a house be washed?

Most Peoria homes benefit from a wash every one to two years. Shaded lots and homes near the river tend to grow algae faster and may want it yearly. It's also a smart move before listing a house for sale.

Can you remove rust or oil stains?

Usually, yes. Rust, irrigation stains, and oil spots need specific treatments beyond a standard wash. Point them out when we quote the job so we bring the right chemicals and set expectations, since old deep stains sometimes lighten rather than vanish.

Do you use my water?

Yes, we hook up to your exterior spigot. It's the standard setup for residential work and keeps the job simple. Commercial jobs with limited water access can be arranged differently.